How To Install Amd Cpu Fan

Steps Download Article

1. i

   Before opening your calculator, make sure that it is unplugged and in a non-static surface. Wood or a glass tabular array is ideal.

2. 2

   Turn off the computer and move it to the not-static surface. Use your screw-commuter to open the instance panel.

   Advertisement

3. 3

   Remove the panel and take a look at the female parent lath. It should look similar to the image.

4. 4

   Now go on to remove your previous CPU estrus sink. In guild to do this, y'all demand to disengage the lever on the right side. Do this by gently pulling up on the lever until information technology becomes unhinged and loose.

   • The CPU should come off with ease.

5. 5

   Check that all the components are in correctly and then that there is no complications in the install process. The CPU should be perfectly flat.

6. 6

   Use the thermal paste onto the CPU. The corporeality of paste used should be about the size of a grain of rice.

7. seven

   Take the replacement heat sink and line information technology up correctly with the lever facing the PCI ports.

8. eight

   Connect the left connector subclass to the left side. This is important considering it allows the lever to lock in the CPU rut sink so that it does non motion.

9. 9

   Connect the correct side. Pull the leaver all the way back and push the bracket down until information technology clicks into identify.

10. x

    Take the lever and push it forward until it clicks into place. If the lever does not lock, terminate pushing the lever. Merely pull the lever back and echo the last two steps over again.

11. xi

    Plug in the wire. There will be a wire that is not connected which is located on the heat sink fan. Take the wire and plug it into the CPU fan socket. It is located near the CPU and has several metal prongs.

    Advertisement

Add New Question

• Question

  Is there a risk of injury doing this?

  

  Peradventure. It depends on whether you are trying to spiral the screws onto the motherboard with a screwdriver or a wood-etching saw fit with a Phillips head. Other than that, there are no serious risks, although you may go a cut on your hand if the screwdriver slips.

Ask a Question

200 characters left

Include your e-mail address to go a message when this question is answered.

Submit

Advertisement

Things You lot'll Need

• Thermal Paste
• Heat sink

• If doing this inside a computer case it is a good idea to have an elbow on the example. Information technology acts every bit a ground to avoid harm to the figurer.

Thanks for submitting a tip for review!

Advertisement

• If the CPU is not installed correctly, the CPU will over-heat and go damaged.

• The installation of the libation must not be done on a carpet.

• Since computers are very sensitive to magnets, magnetized screw drivers must be avoided.

• If the lever is pushed down, the lever will get damaged compromising the lock the heat sink has to the CPU!

• Working inside a computer can cause damage to the computer if you aren't grounded. Wear an anti-static wrist strap or touch a metal tap before making contact with the interior of the computer.

Advertisement

About This Commodity

Thanks to all authors for creating a page that has been read fifty,875 times.

Is this article upward to date?

Source: https://www.wikihow.com/Install-a-CPU-Cooler-in-an-AMD-Motherboard

Posted by: gablerhoudy1951.blogspot.com

Share this post