How To Install Safari Electric Submeter
How To Wire a Single Phase kWh Energy Meter? (3-phase, 4 Wire Energy Meter)
(From the Supply to The Main Distribution Board (MDB)
Below are the the connections diagrams for installation of a Single-Stage (3-stage, iv Wire)) kWh meter (Digital or Analog Energy Meter) from the supply to the main distribution board in habitation.
The Red Wire shows the Alive or Line or Phase and the Blake shows the Neutral wire.
These graphics below shows the above idea in a very elementary way.
- Must read: How To Wire a three-Phase kWh Energy meter?
Installation of unmarried phase kWh Meter (iii-phase, 4 Wire energy meter)
Click epitome to enlarge
Here is another live example of an energy meter which has been installed on the primary pole of source supply.
Click image to enlarge
In the above graphics and diagrams,
PIN = Incoming Phase or Live from the source supply voltage
POUT = Out going Stage or live to the dwelling house main distribution board.
NorthwardIN = incoming Neutral from the source supply voltage.
NUOT = Out going Neutral to the home main distribution board.
Alert: This example shows the most common used system in the world, but in that location are variations as well in some area. The setting may be different in other blazon of kWh or free energy meter in different locations around the world. For safety. Delight contact to the supply and service provider to ostend the connexion type before installation.
Yous may also interested to read in
- How To Wire Switches In Serial?
- How To Wire Lamps in Parallel?
- Stair case wiring excursion diagram, OR How to command a lamp from two different places by ii ,ii-manner switches?
- What is Intermediate switch, its construction, working principle and using in dissimilar electrical wiring (lighting etc) circuits?
Source: https://www.electricaltechnology.org/2012/11/how-to-wire-single-phase-kwh-meter.html
Posted by: gablerhoudy1951.blogspot.com
0 Response to "How To Install Safari Electric Submeter"
Post a Comment